![]() Two arms (on this model) end in male (with pins) outputs to plug in your fans. One ends in a female fan connector with 4 holes to plug into a mobo header. NOTE that this device has only two types or "arms". So you need a simple two-output SPLITTER like thisĪ version with 12" arms also is available. First, you have a small dilemma - four fans, but three headers suited to controlling them. ![]() There is no detail on each screen, but this will do. 3-7 where the general layout of a fan header configuration screen is shown. So do NOT use those last two for any fans. The AIO_PUMP and W_PUMP+ headers are intended to power only the pump unit of a liquid-filled CPU cooling system, and so they do NOT generally allow you to control their speeds at all - they are supposed to run the pump at full speed all the time. Each can be configured separately, and they are the ones you should use for case ventilation fans. The three CHA_FANn headers are tied to a different temperature sensor built into the mobo. The CPU_FAN and CPU_OPT headers are both tied to the temperature sensor inside the CPU chip, and both can be configured to operate separately in BIOS Setup. The mobo has three slightly different types of fan headers.
0 Comments
Leave a Reply. |